New!
SPRAY PLASTERS
AIRLESS JOINTING PLASTER
Ready to use airless spray plaster for interior jointing and skimming of plasterboard.
- Fine finish
- Smooth glide
- Easy to sand
- Ukca & ce certified for jointing
Estimate quantities for levelling and smoothing
m²
- Characteristics
- Technical documents
- Surfaces
- Directions for use
- Application
Characteristics
Ready to use airless spray plaster for interior jointing and skimming of plasterboard.
Code
TTAIRJ25GB
Surface condition
Interior
Task
Jointing plasterboard
Skimming plasterboard
Fine finishing surfaces
Skimming plasterboard
Fine finishing surfaces
Application method
Spray machine
Time between coats
Second coat as soon as the filler is hard and dry to the touch.
Surfaces
Airless Jointing Plaster can be applied to new or renovated substrates,
painted or unpainted:
Gypsum, plasterboard/drywall, old painted substrates, cement,
concrete, cellular concrete.
There is no need to prime or seal the surface before application.
painted or unpainted:
Gypsum, plasterboard/drywall, old painted substrates, cement,
concrete, cellular concrete.
There is no need to prime or seal the surface before application.
Overcoat with
Airless Jointing Plaster can be coated with all types of fillers, paint or wall
coverings.
coverings.
Maximum recommended application thickness
Up to 5 mm.
Mixing rate
Ready to Use.
Ready to paint time
24 to 48 Hours
Working time
No limit
Application tools
Airless machine gun
Recommended temperature and humidity for application
Do not apply at a temperature below +8°C or above +35°C nor at a relative humidity over 70%.
Adhesion
Adhesion filler/substrate (EN 16-566) : > 0,5 Mpa
Coverage g/m² (at 1mm thickness)
1700.00
IAQ (Indoor Air Quality) classification
/
Colour when dry
White
Guarantee
Product guaranteed for 12 months from purchase, in original package and stored away from sunlight and frost.
Clean tools with
Water.
Pack sizes
- Bag 25 KG
Surfaces
Airless Jointing Plaster can be applied to new or renovated substrates,
painted or unpainted:
Gypsum, plasterboard/drywall, old painted substrates, cement,
concrete, cellular concrete.
There is no need to prime or seal the surface before application.
painted or unpainted:
Gypsum, plasterboard/drywall, old painted substrates, cement,
concrete, cellular concrete.
There is no need to prime or seal the surface before application.
Directions for use
Do not apply on bonded coatings.
Do not apply over polystyrene.
Do not apply on damp grounds.
Do not apply on exterior surfaces.
Application
1
Remove the gun filters (strainer, suction and pencil) to enable the product flow. Load the spray plaster into your bucket or hopper and prime the airless machine in water.
2
We recommend suitable nozzles for each of our spray plasters. Please refer to the product packaging or the technical data sheet
3
Stand at right angles to the wall at a distance of 0.7 to 1m. Apply at a constant 90° spraying angle, 1 square metre at a time, moving the gun parallel to the substrate at a constant speed to ensure an even coating of the product. Proceed in cross passes, overlapping the previous pass by 50% as you progress.
4
After spraying, skim with a blade or trowel at least 50cm long.
If also spraying ceilings it is recommended to spray them first, before starting on the walls.
Apply a second coat as necessary as soon as the first one is dry.
If also spraying ceilings it is recommended to spray them first, before starting on the walls.
Apply a second coat as necessary as soon as the first one is dry.
5
Wait until completely dry, then sand as required.